If you are planning to build an amplifier using the Abletec C1, here is what you need to know:
: Do not leave any input pins floating. Tie unused logic inputs directly to VCCcap V sub cap C cap C end-sub GNDcap G cap N cap D
If you are currently debugging or integrating this component, let me know: The you are applying to the component.
Overview
The datasheet warns that without proper termination on RS-485 lines exceeding 10 meters, data corruption will occur at baud rates above 115.2 kbps.
(Invoking related search suggestions.)
Receives the pulse-width modulated (PWM) or analog input signal destined for the modulation stage.
: Generation of high-frequency carrier signals necessary to drive Class-D MOSFET switches.
Struggles with extreme low-frequency (infra-bass) power delivery; performance at high frequencies (10kHz+) shows slightly higher distortion than modern "super-amps".