Anilam Mini Wizard A163 Manual Top: A Complete Guide to Operation and Maintenance The Anilam Mini Wizard A163
Used for entering coordinate dimensions and tool offsets.
: Use the numeric keypad to enter a value and press the axis key to preset that dimension. anilam mini wizard a163 manual top
: Includes standard Inch/Metric conversion and the ability to toggle between Radius and Diameter modes for lathe work.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Anilam Mini Wizard A163 Manual Top: A Complete
For machinists and metalworking professionals, a reliable Digital Readout (DRO) is an essential tool on any milling machine, lathe, or grinder. For many years, the Anilam Mini Wizard series, particularly the model A163, was a workhorse in shops around the world, providing precise position feedback to improve accuracy and efficiency. Even though these units are now legacy products, many remain in active service. This guide is dedicated to the Anilam Mini Wizard A163, providing a single source for understanding its operation, finding its manual, and troubleshooting common problems.
A: No. It does Bolt Hole Circles and linear steps only. For arcs, you need a Wizard 411 or newer model. This public link is valid for 7 days
For those looking to integrate, repair, or replace the unit, here are its key technical specifications.
Anilam Mini Wizard A163 is a legacy digital readout (DRO) console designed for manual machine tools like mills and lathes. It provides real-time position feedback by processing signals from linear glass scales or encoders. Control System Labs Key Features & Functions Axis Monitoring:
| Problem | Likely Cause(s) | Troubleshooting Steps / Solution | | :--- | :--- | :--- | | (e.g., moving 0.200" but reading 0.400") | Scale resolution mismatch between the new scale and the DRO's setting. | 1. Access the setup mode (DIP switches or keypad method) and verify the resolution setting against the new scale's specs. 2. Adjust the resolution configuration as needed. | | Unit shows 'Error Code 5' on startup | General internal electronics failure or communication error. | 1. Try power-cycling the unit. 2. Check for loose internal connections. 3. Contact a specialist like Ray Ayers for repair options, as this likely indicates a component-level failure. | | Scales not reading at all | Faulty scale, damaged ribbon cable, or misalignment of the read head. | 1. Inspect the ribbon cable for cuts, kinks, or a poor connection at the DRO and the scale. 2. Ensure the read head is clean and properly aligned with the glass scale. The Acu-Rite AR-5 manual contains a drawing of the correct alignment. | | Cannot enter Setup using '8' key | Unit may be an older model that uses DIP switches, or the keypress sequence is incorrect. | 1. Try a different sequence: Some users reported that pressing the '8' key twelve times, or a combination of the '8' and another key, works. 2. Open the unit: As described, look for physical DIP switches on the internal circuit board. | | Unit powers on but display blinks continuously | Normal startup sequence interrupted, or a stuck button on the keypad. | Press any key (like 'X' or 'Y') to see if the blinking stops. If the problem persists, check for a stuck button or a malfunctioning keypad membrane. |