The transmitter LCD will illuminate, and the receiver's LED will flash green to confirm a successful connection.
Shows timer settings, battery status, and channel selection.
To pause or cancel the program at any point, press the button again. 7. Troubleshooting and Maintenance Potential Cause The camera does not shoot Cable loose or incorrectly inserted. Securely push the cable into both the receiver and camera. The camera does not shoot Camera is autofocusing but cannot lock lock focus. Switch lens to Manual Focus (MF). Receiver doesn't respond Channels do not match. Re-pair the devices using the Channel Pairing steps. Display is faint or missing text Low battery power. Replace all AAA batteries in the transmitter. The remote skips interval shots INTVL time is shorter than LONG time. Increase INTVL time to exceed exposure time. Care and Maintenance
Supports single shooting, continuous shooting, Bulb (long exposure), and delay shooting. [2, 5] Programmable Timer: aodelan wtr2 user manual
What are you pairing with the WTR-2?
To help clear up any issues with your setup, please let me know you are using, which specific cable link you have attached, and what type of shot you are trying to capture. Share public link
The Timer [WTR-2(T)] can act as a wireless controller for the Receiver [WTR-2(R)], or it can connect directly to the camera via cable for wired operation. Setup and Operation The transmitter LCD will illuminate, and the receiver's
Triggering the camera from a distance to avoid spooking subjects. 2. What’s in the Box Your package should include: 1x Timer Transmitter ( 1x Receiver (
Plug the shutter release cable into the receiver’s "OUT" port and your camera’s remote terminal.
By following the guidelines and recommendations outlined in this user manual, you'll be well on your way to becoming an Aodelan WTR2 expert, and unlocking the full potential of this incredible device. The camera does not shoot Camera is autofocusing
Plug the other end into your camera’s remote control terminal. 📶 Channel Configuration and Wireless Pairing
Insert two AAA batteries into each unit, ensuring correct polarity. Slide the covers back until they click locked. Physical Installation