: Built-in self-diagnostics help monitor system health and maintenance needs. Programming and Setup
Ensure the IP address configuration on the scale matches your store's subnet.
: Instructions on adding secondary information like storage directions, product of origin, and use-by dates to labels. System Setup & Connectivity digi sm 5000 scale user manual
. The display will reset to zero, allowing you to weigh only the contents. Loading Labels Open the printer compartment (usually on the side). Unlatch and slide out the label cassette.
The display will enter the interface, displaying internal raw A/D (Analog-to-Digital converter) counts. : Built-in self-diagnostics help monitor system health and
Access the internal calibration switch (usually protected by a physical lead wire seal or access panel underneath or on the side of the scale body).
The DIGI SM-5000 is a PC-based self-service scale featuring a 12.1" touch display System Setup & Connectivity
With the platter clear, press the or [TARE] key to lock in the zero base reference point.
| Error Code | Meaning | Solution | |------------|---------|----------| | Err 1 | Overload (weight exceeds max capacity) | Remove weight immediately to avoid load cell damage. | | Err 2 | Underload (platform missing or load cell disconnected) | Check if the weighing platform is properly seated. | | Err 5 | Zero range exceeded | Remove any weight, press ZERO . If persists, recalibrate. | | Lo or BATT | Low battery (battery-powered models) | Replace batteries or connect AC adapter. | | UnSt | Unstable weight (vibration or airflow) | Move scale to stable surface, away from drafts. | | Err 8 | EEPROM error (memory corruption) | Contact service technician; may require factory reset. |