Disco - 240 Dmx Controller Manual

The Disco 240 features a standard 3-pin XLR output (both male and female connectors are usually present for daisy-chaining).

To help me tailor any specific programming shortcuts, what (such as moving heads, par cans, or lasers) are you connecting, and how many channels does each light use? Share public link

: Press the Auto/Del button so its indicator LED lights up. disco 240 dmx controller manual

Press and hold the Program button for 3 seconds to exit. 4. Programming Chases (Sequences)

Press and hold the Program button for three seconds until the indicator LED blinks. The Disco 240 features a standard 3-pin XLR

Use the Bank Up/Down buttons to choose where you want to save the scene.

If your lights flicker or behave erratically over long cable distances, plug a DMX Terminator (a 120-ohm resistor soldered across pins 2 and 3 of a male XLR plug) into the DMX output of the very last fixture in your chain. Press and hold the Program button for 3 seconds to exit

Located on the far left, these buttons select which lighting fixtures you are currently controlling. Each button assigns a block of 16 DMX channels to the faders. Channel Faders (1–8) and Page Select Button The center of the console features 8 physical faders.

When your show is complete, press the button again. The LED light turns off , saving all your data to the internal 128K memory.

Press the MIDI/Add (or Program/Record) button, then immediately press the Scene button (1–8) where you want to store the look. All LEDs on the controller will flash, confirming the scene is saved.