Press the buttons to adjust the year, then press Clock Set to confirm.
When you first plug in your ETech AccuSet, it may not display your local time immediately. Follow these steps to sync it:
A: First, check that the DST switch is correctly set for your region. Also, the atomic time signal can be affected by interference from other electronics, metal structures, or bad weather. Try moving the clock to a different location near a window. You can also manually set the time by following the instructions in the "Setting the Time" section.
Press and hold the button until the zone indicator flashes on the screen.
Maximum output: 5V/1A. Not suitable for high-power tablets or laptops.
Allows you to set two independent wake-up times for different schedules or users.
Check that the alarm switch is set to "BUZZER" or "RADIO" and that the volume is high enough.
Press and hold the (or Alarm 2 ) button until the display numbers flash.
: Press the Clock Set button once more to transition the flashing indicator to the minute digits. Adjust using the navigational buttons.
The clock comes pre-programmed with the current time (EST). Battery Backup: Maintains settings during power outages. Dual/Single Alarm: Options to wake up to radio or buzzer. Large LED Display: Easy to read from across the room. Sleep/Snooze Function: For added convenience. 2. Getting Started: Initial Setup Upon unpacking your Etech Accuset clock radio , follow these steps to ensure optimal performance:
Press and hold the (or Time Set ) button until the year digits flash on the display.
: Slide the ALARM ON/OFF switch to the ON position. An indicator light should appear on the display to confirm it is active.