Id6100 Danieli Manual Hot Now

Its optical system is composed of a filter and an aspherical lens that focuses the infrared emission from the rolled material onto a . The position of the hot steel within the detector's field of view is converted into an analog signal.

While the unit is designed for harsh environments, it should be installed to avoid direct exposure to cooling water spray or excessive dust build-up on the lens.

Fix : Clean the outer optical lens shield and increase the internal sensitivity potentiometer slightly to pierce through dense steam pockets. id6100 danieli manual hot

: It typically operates on 20–30V DC power. Procurement and Availability

Root Cause: Lens is dirty, or internal ambient temperature of the scanner is exceeding safe operating limits. Its optical system is composed of a filter

, providing both digital presence signals and analog signals proportional to the material's width and position. Sensitivity Control:

: A manual trimmer located beneath the rear protective cap allows operators to fine-tune the detection threshold. Adjusting this ensures the system filters out background scale flakes or ambient factory glare while responding to the main product body. Fix : Clean the outer optical lens shield

is a critical component in modern steel manufacturing, specifically designed for high-performance automation in harsh, hot environments . As part of Danieli Automation's ID6000 series, the Go to product viewer dialog for this item.

Use the built-in rear alignment LEDs during setup to verify the field of view covers the entire 830–1000 mm sweep profile. Thermal Protection and Cooling

utilizes specialized scanning geometry and high-speed photo-detectors. Specification Detail Hot Metal Detection (HMD), Loop Scanning, Edge Tracking Sensor Type Linear CCD Array (Charge-Coupled Device) Operating Voltage 20V DC to 30V DC Material Temperature Detection 750 °C and higher (Infrared emission spectrum) Scanning Range / Window 830 mm to 1000 mm Output Signals Digital (Material Presence) & Analog (Material Position) Housing Construction

: Detection of hot rolled products (bars, billets, or slabs) without physical contact. Operating Temperature : While specific models vary, the