Kincaid Radio Controlled Clock Instruction Manual ((link)) -

If you own a Kincaid radio-controlled clock, you have a timekeeper designed to keep perfect time, automatically adjust for Daylight Saving Time (DST), and run efficiently for years. However, setting up these clocks or regaining a lost signal can sometimes be confusing without the original documentation.

Press and hold the or REC button on the back of the clock for 3 to 5 seconds. kincaid radio controlled clock instruction manual

Do not hang or place the clock on metal surfaces, structural steel frames, or inside reinforced concrete buildings, as metal acts as a shield against radio waves. If you own a Kincaid radio-controlled clock, you

: Stop pressing the button when the correct time is reached; the clock will exit manual mode after a few seconds of inactivity. Troubleshooting & Maintenance Hands Spinning Randomly : This usually indicates a low battery Do not hang or place the clock on

: Press and hold the SET (or M. SET ) button for about 3–5 seconds until the hands start moving.

Q: Why is my Kincaid radio controlled clock not receiving the radio signal? A: Check that the clock is at a reasonable distance from any electronic devices that may interfere with the radio signal. Move the clock to a different location and try again.

Digital Kincaid clocks require you to select your local North American time zone to offset the UTC/GMT time received by the atomic signal. Choose the abbreviation or setting that matches your location: / PT / PACIFIC: Pacific Standard Time M / MT / MOUNTAIN: Mountain Standard Time C / CT / CENTRAL: Central Standard Time E / ET / EASTERN: Eastern Standard Time 3. Managing Daylight Saving Time (DST)