Open the Marlin folder in VS Code. Adjust these critical settings in Configuration.h based on your specific machine:
The compiled firmware has wrong LCD controller definition (usually CR10_STOCKDISPLAY vs REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER ). Fix: In Configuration.h , verify #define LCD_LANGUAGE en and #define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER for the stock Sapphire Pro screen. two trees sapphire pro firmware upd
: Stock firmware sometimes lacks robust safety triggers. Updates keep your home safe from heating failures. Open the Marlin folder in VS Code
: Run PID calibration for both the bed and the hotend to prevent thermal fluctuations. Use the command M303 E0 S210 C8 U1 for the hotend. : Stock firmware sometimes lacks robust safety triggers
This process requires an external computer (like a Raspberry Pi) running the Klipper software suite. The following outlines the steps for compiling Klipper for the mainboard:
Locate the compiled file, typically named Robin_nano35.bin (or Robin_nano.bin depending on your board version).
Do not turn off the machine or remove the card until the refresh is 100% complete.
Open the Marlin folder in VS Code. Adjust these critical settings in Configuration.h based on your specific machine:
The compiled firmware has wrong LCD controller definition (usually CR10_STOCKDISPLAY vs REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER ). Fix: In Configuration.h , verify #define LCD_LANGUAGE en and #define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER for the stock Sapphire Pro screen.
: Stock firmware sometimes lacks robust safety triggers. Updates keep your home safe from heating failures.
: Run PID calibration for both the bed and the hotend to prevent thermal fluctuations. Use the command M303 E0 S210 C8 U1 for the hotend.
This process requires an external computer (like a Raspberry Pi) running the Klipper software suite. The following outlines the steps for compiling Klipper for the mainboard:
Locate the compiled file, typically named Robin_nano35.bin (or Robin_nano.bin depending on your board version).
Do not turn off the machine or remove the card until the refresh is 100% complete.