V2000-c Rfid Access Control User Manual !!hot!! Jun 2026

: Incorrect relay wiring or insufficient power to the lock.

: Press * to exit and return to normal operation.

The device automatically assigns the next available User ID slot. V2000-c Rfid Access Control User Manual

You can assign unique User IDs (001 to 999 or higher) to keep track of individual tokens. Enter Programming Mode. Press 1 . Enter a 3-digit or 4-digit (e.g., 001 ) + # .

Repeat steps 3 and 4 for additional cards, or press * to exit. Adding a Public Access PIN Enter Programming Mode. Press 2 . Enter a + # . Exit Programming Mode. Deleting Users Delete by User ID: Enter Programming Mode →right arrow Press 3 →right arrow Enter User ID + # →right arrow Delete by Swiping Card: Enter Programming Mode →right arrow Press 3 →right arrow Swipe the card to be deleted →right arrow : Incorrect relay wiring or insufficient power to the lock

If you have a stack of cards and do not care about tracking individual user slots: Enter programming mode. Press 1 .

Proper installation requires understanding the terminal block connections on the back of the V2000-C unit. Before wiring, always disconnect the 12V DC power supply to prevent short circuits. Terminal Definitions Positive power input (12V DC) GND (Black): Negative power input / Ground reference PUSH (Yellow): Low-level trigger input for exit buttons OPEN (Green): High-level trigger or door switch loop You can assign unique User IDs (001 to

The relay contacts (PUSH1, PUSH2) provide dry contact output for controlling electric locks.